Why does my Husqvarna Lawn Mower have a battery problem?
If your Husqvarna Lawn Mower displays 'Battery problem', it could be due to several reasons. The battery might not be connected properly, so dismantle the mower and check the battery connection. The battery might be faulty, so check the connection again. Ensure you are using only original batteries from Husqvarna. The main circuit board could also be faulty.
Why does my Husqvarna GARDENA SILENO R100Li Lawn Mower have no drive?
If your Husqvarna Lawn Mower has 'No drive', it might be caught in something. Free the mower and fix the cause. If it is due to wet grass, wait until the lawn dries. The working area might have a steep slope; isolate slopes steeper than 40%. If the guide wire is on a slope, ensure it's laid at an angle across the slope.
Why does my Husqvarna GARDENA SILENO R100Li need manual charging?
If your Husqvarna Lawn Mower displays 'Needs manual charging', the mower is set to the Secondary area operating mode. Place the mower in the charging station; this is normal and requires no further action.
Why does my Husqvarna GARDENA SILENO R100Li Lawn Mower have no loop signal?
If your Husqvarna Lawn Mower displays 'No loop signal', it could be due to several reasons. The boundary wire might be broken, or the power supply isn't connected. Also, the connection between the mower and charging station may be broken. The boundary wire could be laid incorrectly around an island, or there might be disturbances from metal objects or buried cables. The power voltage cable could be damaged or not connected, or the boundary wire isn't connected to the charging station. If ECO mode is on, place the mower in the charging station, press START, and close the hatch. Check the LED on the charging station to troubleshoot the loop signal.
What to do if Husqvarna GARDENA SILENO R100Li goes outside working area?
If your Husqvarna Lawn Mower is 'Outside working area', it can be due to crossed boundary wire connections at the charging station. The boundary wire might be too close to the edge or laid incorrectly around an island. The working area may slope too much at the boundary wire. If there are disturbances from magnetic objects or the mower has hard time distinguishing the signal from an installation close by, try moving the boundary wire and creating additional islands or generate a new loop signal.
What to do if Husqvarna GARDENA SILENO R100Li Lawn Mower cutting system is blocked?
If your Husqvarna Lawn Mower says 'Cutting system blocked', grass or another object may be wrapped around the blade disc. Check the blade disc and remove any object. The blade disc might be in a pool of water, so move the mower and fix the water collection issue. The blade motor could be defective, so ensure it has the right speed. The main circuit board might be defective, so change it. The cabling to the blade motor could be damaged or faulty, so check and repair or replace the blade motor.
How to get Husqvarna Lawn Mower unstuck when it is trapped?
If your Husqvarna Lawn Mower is 'Trapped', it means the mower has got caught in something. Free the mower and fix the reason it became trapped. The mower might be stuck behind obstacles, so check for anything making it hard to move. Also, check that the body is properly secured in the front and rear rubber dampers, as one of the body’s attachments may have come loose.
What to do if Husqvarna GARDENA SILENO R100Li wheel motor is blocked?
If your Husqvarna Lawn Mower displays 'Wheel motor blocked, right/left', it means grass or another object has wrapped around the drive wheel. Check the drive wheel and remove any objects.
What does it mean when Husqvarna GARDENA SILENO R100Li Lawn Mower says mower lifted?
If your Husqvarna Lawn Mower shows 'Mower lifted', the lift sensor has been activated because the mower got stuck. Free the mower and fix the reason it got stuck. One of the lift sensor magnets might be inverted or missing, so check the magnets. The lift sensor itself could be faulty, so check it.
What to do if Husqvarna GARDENA SILENO R100Li Lawn Mower has wheel drive problem?
If your Husqvarna Lawn Mower displays 'Wheel drive problem, right/left', the wheel motor may be faulty, so check its function when idling. The main circuit board could be faulty, so replace it. The cabling to the wheel motor might be damaged, so check if it's repairable or replace the wheel motor.
General| Brand | Husqvarna |
|---|---|
| Model | GARDENA SILENO R100Li |
| Category | Lawn Mower |
| Language | English |
Details components of Husqvarna Automower models 310/315.
Details components of GARDENA Sileno/Sileno+ models.
Guidelines for optimal placement and setup of the charging station.
Instructions for installing the boundary wire.
Installation of the guide wire for mower navigation.
Performing a comprehensive automatic test of mower components.
Updating mower software via Autocheck EXP.
Detailed procedure for replacing the mower's main circuit board.
Lists and explains fault and information messages from the mower.
Describes common symptoms and their potential causes and actions.
Step-by-step guide to diagnose loop signal issues.
Methods for locating breaks in the boundary wire.
To Next Page