Need help?Do you have a question about the Husqvarna Rider 18 AWD and is the answer not in the manual?
General| Manufacturer | Husqvarna |
|---|---|
| Product Name | Rider 18 AWD |
| Category | Lawn Mower |
| Power Output | 18 hp |
| Net Power RPM | 3600 RPM |
| Fuel Type | Gasoline |
| Fuel Tank Capacity | 12 L |
| Cutting Height | 25-75 mm |
| Drive Type | AWD |
| Transmission | Hydrostatic |
| Uncut Circle | 30 cm |
| Blade Engagement | Electric |
| Blades | 3 |
| Deck Material | Steel |
Essential safety instructions and warnings for operating and maintaining the machine.
Details on risks like sparking, battery hazards, and hot surfaces.
Lists and illustrates specialized tools needed for service and repair tasks.
Technical data including dimensions, engine details, electrical specs, and tightening torques.
Steps for initial machine setup, checks, and customer handover.
Outlines routine maintenance intervals, tasks, and service schedules.
Covers battery, oil levels, wheels, steering wheel, and initial test runs.
Overview of the rider's general design, engine, steering, driving, and cutting unit.
Details the front-mounted cutting units and their operational modes.
Detailed steps for engine removal, installation, and routine oil services.
Covers repairs for steering, hydrostatic transmission, cables, and hydraulic system.
Procedures for servicing the cutting unit, belts, blades, and BioClip plug.
Instructions for servicing front and rear axles, including synchronisation.
Illustrates the electrical system layout and component identification.
Covers ignition lock, main fuses, and the machine's safety interlock system.
Emphasizes cleanliness and proper practices for hydraulic system upkeep.
Covers specific tasks like bleeding the drive system and adjusting transmission neutral position.
Diagnostic steps for when the engine fails to start.
Troubleshooting for issues like rough running, stalling, or low power.
Diagnosing and resolving issues with machine speed, power, and drive engagement.
Addressing overheating, leaks, and abnormal noises in the transmission system.
Diagnosing and resolving uneven cutting results and machine vibrations.
To Next Page
