To Next PageTo Next Page
Need help?Do you have a question about the Husqvarna ST 151 and is the answer not in the manual?
General| Brand | Husqvarna |
|---|---|
| Model | ST 151 |
| Category | Snow Blower |
| Language | English |
Important warnings and cautions for safe operation, including symbols for attention and potential hazards.
Instructions on how to read, understand, and become familiar with the snow thrower's controls and operation.
Steps to take before operating, including area inspection, clothing, and fuel handling safety.
Instructions for unpacking, verifying loose parts, and assembling the operator handle.
Procedure for attaching the discharge chute to the chute base using provided hardware.
Step-by-step guide for adding the correct type and amount of oil to the engine.
Identifies and labels the various parts of the snow thrower using a diagram.
Instructions for safely filling the fuel tank with gasoline, including precautions.
Procedure for checking the engine oil level before starting to prevent damage.
Step-by-step guide for starting the snow thrower using recoil or electric start methods.
How to engage and disengage the auger blades using the control bar for safe operation.
Procedure for safely stopping the snow thrower's engine by removing the ignition key.
Instructions on how to adjust the direction and angle of the snow discharge chute.
Steps to take after operation to prevent parts from freezing in cold weather.
Detailed procedure for safely clearing a clogged discharge chute using a tool.
Advice for efficient and safe snow throwing, including timing, overlapping paths, and machine cleaning.
A schedule outlining regular service tasks to be performed before/after use, every 25 hours, or seasonally.
Procedures for checking and adjusting the control cable for proper auger engagement and disengagement.
Guidance on inspecting wear on auger blades and scraper bar and when to seek professional replacement.
Step-by-step instructions for draining and refilling the engine oil, including safety precautions.
Instructions for removing, inspecting, gapping, and installing the spark plug.
Completes the spark plug servicing procedure, including reassembly steps.
Detailed steps for removing and installing a new auger v-belt, including pulley and arm adjustments.
Comprehensive steps for preparing the snow thrower for long-term storage, including cleaning and fuel system management.
Lists common causes and corrections for the engine failing to start.
Addresses issues like power loss, rough idling, or engine stalling and their solutions.
Covers causes and fixes for excessive vibration, handle movement, and hard-to-pull recoil starters.
Solutions for issues related to snow discharge, jammed augers, or non-functioning lights.
Placeholder for service-related information or reminders.
