18
Fig. 32
TO DUMP BAGGER (See Fig. 32)
MANUAL DUMP ONLY
Your tractor is equipped with a Dump Bag Alarm. To turn
off the alarm disengage the attachment clutch.
• Position tractor in location you wish to dump bag ger.
• Ensure transaxle is in the neutral position. Set parking
brake.
• Raise dump handle to its highest position. Pull han-
dle forward to raise bagger and dump clippings.
• To continue mowing, Ensure bag ger is down and in
proper operating po si tion which will allow mower to
operate.
OPERATION
PURGE TRANSMISSION
CAUTION: Never engage or disengage free-
wheel lever while the engine is run ning.
To ensure proper operation and performance, it is rec om-
mend ed that the transmission be purged before operating
tractor for the first time. This procedure will remove any
trapped air inside the transmission which may have de vel-
oped during shipping of your tractor.
IMPORTANT: SHOULD YOUR TRANSMISSION RE QUIRE
REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD
BE PURGED AFTER REINSTALLATION BEFORE OPERATING
THE TRACTOR.
1. Place tractor safely on a level surface - that is clear
and open - with engine off and parking brake set.
2. Disengage transmission by placing freewheel control
in disengaged position. (See “TO TRANSPORT” in
this section of manual.)
3. Sitting in the tractor seat, start engine. After the en-
gine is running, move throttle control to slow position.
Dis en gage parking brake
Fig. 31
RESETTING IGNITION SYSTEM PASSCODE
(See Fig. 31)
The SmartSwitch Ignition is preset at the factory with the
default code "321". To reset or change the passcode, the
operator does not have to be seated on the tractor.
1. Press the SmartSwitch Ignition (SSI) button (F) once (or
sit on the seat). Ensure the indicator is blinking blue.
2. Press and hold the (1) and (3) buttons simultaneously
for approximately three (3) seconds until the SSI button
changes to solid blue.
3. Using the numbered buttons, enter the desired pass-
code. The passcode may be anywhere from one to
five digits in length.
4. After the desired passcode has been entered, press
the SSI button (F) once.
NOTE: When the indicator flashes green, the passcode has
been accepted. If the indicator blinks red, the passcode has
not been accepted. Wait until the indicator returns to blink-
ing blue and repeat this procedure starting from step two.
F
CAUTION: At any time, during step 4, there
may be movement of the drive wheels.
4. Depress forward drive pedal to full forward position,
hold for five (5) seconds and release pedal. Depress
reverse drive pedal to full reverse position, hold for five
(5) seconds and release pedal. Repeat this procedure
three (3) times.
5. Shut- off engine and set parking brake.
6. Engage transmission by placing freewheel control
in engaged position. (See “TO TRANSPORT” in this
sec tion of manual.)
7. Sitting in the tractor seat, start engine. After the engine
is running, move throttle control to half (1/2) speed.
Disengage parking brake.
8. Drive tractor forward for approximately 5 feet (1,5 m)
then backwards for 5 feet (1,5 m). Repeat this driving
procedure three times.
Your transmission is now purged and now ready for normal
op er a tion.
To Next Page
Loading...
