9
ASSEMBLY
TO ADJUST BAGGER FULL LEVER/EXTENSION
Slide bagger full extension (3) to the desired position.
• For the heaviest/wet grasses, slide bagger full exten-
sion (3) all the way in.
• For the lightest/driest grasses, pull bagger full exten-
sion (3) all the way out.
• Place curved end of the bagger spring latch onto
mounting bolt (3) and secure with nut (4) as shown.
Tighten firmly.
NOTE: The bottom of the bagger assembly should contact
the loop end so that it is held securely when closed.
NOTE: If the bagger assembly height is adjusted, it may
be necessary to adjust the bagger spring latch. To adjust,
remove the nut (4) and move the bagger spring latch to the
appropriate hole in the backplate (1), ensuring the bagger
assembly will be securely closed. Retighten nut securely.
TO INSTALL BAGGER FULL LEVER/EXTENSION
Before installation or adjusting, tractor engine must be shut
off and parking brake engaged.
• Remove center discharge chute. (See "To Remove
Center Chute" in section 6 of this manual.)
• Remove bolt (1) from chassis. Place cover (2) in slots
(3) in backplate. While holding cover in place, place
lever (4) through slot and reinstall bolt (1). Adjust as
needed.
1
1
4
2
3
Fig. 17
Fig. 16
• Slide bagger assembly into proper position.
• Once bagger assembly is in proper position, tighten
adjustment bolts (2) on both sides to 100 In-Lbs/11,2
Nm. Do NOT overtighten.
• Readjust if necessary.
VERTICAL ADJUSTMENT
If necessary, the vertical position of the bagger assembly
can be adjusted to maintain proper alignment (B) between
the fender and the bagger assembly top.
• Replace bagger assembly onto bagger supports (4).
• Readjust if necessary.
• Remove bagger assembly.
• Do NOT remove; ONLY loosen nuts (3).
• Raise or lower the bagger support brackets (4) to proper
position and retighten nuts (3).
4
3
B
Fig. 13
Fig. 14
TO INSTALL BAGGER SPRING LATCH
(See Figs. 15 and 16)
The bagger spring latches are located on the back plate (1),
one in each of the bottom corners.
Before installing, tractor engine must be shut off and
parking brake engaged.
• Install each bagger spring latch with the loop end (2)
down and facing towards the bagger assembly.
• Place the mounting bolt (3) through the backplate.
2
1
3
4
Fig. 15
To Next Page
Loading...
