Husqvarna TS 112 User Manual (English)

Questions and Answers:

B
Brittany MeyerAug 23, 2025
Why won't my Husqvarna Lawn Mower engine start?
- M
  Marilyn ValenciaAug 23, 2025
  Several factors can prevent your Husqvarna Lawn Mower engine from starting. These include: * No fuel in the fuel tank: Fill the fuel tank. * Incorrect throttle control position: Refer to the start instructions. * Defective spark plug: Replace the spark plug. * Dirty air filter: Clean or replace the air filter. * Clogged fuel filter: Replace the fuel filter. * Water in the fuel: Remove all fuel from the fuel tank and the carburetor. Fill the fuel tank with new fuel and replace the fuel filter. * Loose or damaged wires: Check all wires. * Incorrectly adjusted engine valves: Speak to an approved service agent. * Flooded engine: Wait 2–3 minutes before trying to start the engine again. * Bad fuel in the fuel tank: Replace the fuel in the fuel tank.
H
hubbardronaldAug 25, 2025
What to do if my Husqvarna Lawn Mower battery does not charge?
- M
  Mr. Daniel Frazier PhDAug 25, 2025
  If your Husqvarna Lawn Mower battery isn't charging, consider these possible causes: * Defective main fuse: Replace the main fuse. * Defective battery: Replace the battery. * Disconnected charging cable: Connect the charging cable. * Bad connection at the cable connectors on the battery terminals: Check the battery connections.
D
Deborah AyalaAug 25, 2025
What to do if the engine backfires when the Husqvarna Lawn Mower engine stops?
- V
  Vanessa SmithAug 26, 2025
  If the engine backfires when your Husqvarna Lawn Mower engine stops, make sure the throttle control is in the idle position. Put the throttle control in the idle position.
C
Christina BellAug 28, 2025
How to troubleshoot a Husqvarna TS 112 that won't start?
- L
  Leslie FrenchAug 28, 2025
  If your Husqvarna Tractor engine won't start, several factors could be at play. First, ensure the fuel tank has sufficient fuel. If the fuel level is adequate, check the throttle control position against the start instructions. A defective spark plug, a dirty air filter, or a clogged fuel filter can also prevent the engine from starting; consider replacing or cleaning these components as necessary. Water or bad fuel in the tank can also cause starting issues, so replace the fuel and the fuel filter. Inspect all wires for looseness or damage. If the engine is flooded, wait 2–3 minutes before attempting to restart. For engine valve adjustments, it's best to consult an approved service agent.
M
Mark FischerAug 31, 2025
How to improve the cutting result of my Husqvarna TS 112?
- N
  novakshawnSep 1, 2025
  If you're getting an unsatisfactory cutting result with your Husqvarna Tractor, start by checking if the blades are blunt or damaged; if so, sharpen or replace them. Ensure the cutting deck is parallel and adjust if necessary. Avoid cutting wet or long grass; for long grass, start with a higher cutting height and gradually decrease it. Make sure the tire pressure is correct and that you're not operating the product at too high a speed. Finally, check the drive belt for the cutting deck and replace it if it's worn or damaged.
S
sandrarichardsonSep 1, 2025
What to do if the blades on my Husqvarna Tractor won't rotate?
- K
  Katherine SmithSep 1, 2025
  If the blades on your Husqvarna Tractor cannot rotate, check for any blockage in the clutch mechanism and remove it. A worn or damaged drive belt for the cutting deck can also prevent rotation, so replace it. For issues with an idler pulley or a blade pulley that won't turn, it's recommended to consult an approved service agent.
E
Ebony DavisSep 3, 2025
Why does my Husqvarna TS 112 engine backfire when stopping?
- L
  lcervantesSep 3, 2025
  If your Husqvarna Tractor engine backfires when it stops, make sure to put the throttle control in the idle position.
B
Brian JohnsonSep 5, 2025
Why is my Husqvarna Lawn Mower vibrating?
- M
  Megan ReedSep 5, 2025
  Vibration in your Husqvarna Lawn Mower can be attributed to: * Loose blades: Tighten the bolts on the blades. * Damaged or unbalanced blades: Balance or replace the blades. * Loose engine: Tighten the engine bolts.
B
Beth Haley DDSSep 6, 2025
What causes my Husqvarna Lawn Mower engine to overheat?
- J
  Jessica BraunSep 6, 2025
  An overheating Husqvarna Lawn Mower engine can be caused by: * Engine overload: Decrease the workload. * Blocked air intake or cooling fins: Clean the air intake and the cooling fins on the engine. * Defective cooling fan: Speak to an approved service agent. * Low engine oil level: Check the engine oil level and add engine oil if necessary. * Defective ignition lock: Speak to an approved service agent. * Defective spark plug: Replace the spark plug.
J
Jessica JacksonSep 8, 2025
What to do if my Husqvarna Lawn Mower blades cannot rotate?
- D
  Dale JohnsonSep 8, 2025
  If the blades on your Husqvarna Lawn Mower cannot rotate, it might be because: * There is blockage in the clutch mechanism: Remove the blockage. * The drive belt for the cutting deck is worn or damaged: Replace the drive belt for the cutting deck. * An idler pulley does not turn: Speak to an approved service agent. * A blade pulley does not turn: Speak to an approved service agent.

Husqvarna TS 112 Specifications

General

Engine manufacturer	Briggs & Stratton
Transmission type	Hydrostatic
Cutting width	30 inches
Cutting height steps	6
Blades	2
Nose wheel	Yes
Steering wheel type	Standard
Weight	120 kg
Engine Type	Gasoline
Cylinders	1
Fuel Type	Gasoline
Cylinder displacement	344 cm³
Collector	Optional
Deflector	Yes
Mulch kit	Optional
Cutting height, min-max	1.5-4 inches

Summary

Introduction

Pre-delivery inspection and product numbers

Checks performed before product delivery to the customer.

Product description and intended use

Details about the lawn tractor, its engine, and specified applications.

Insurance advice

Advice on obtaining insurance coverage for the new product.

Product overview (TS 112)

Control panel overview

Identifies and describes the main controls and features of the TS 112 model.

Product overview (TS 114)

Control panel overview

Identifies and describes the main controls and features of the TS 114 model.

Operator Presence Control and work light

Explains the safety system and how to operate the work light.

Symbols on the product

Safety and operational symbols

Explains the meaning of various symbols found on the product for safety and operation.

Product safety labels and warnings

Product liability and danger labels

Highlights important danger labels and outlines manufacturer's liability limitations.

Safety instructions

Safety definitions and general instructions

Defines safety terms and provides fundamental safety guidelines for operation.

Safety instructions

Safety regarding children and unsupervised operation

Precautions for children's safety and rules for not leaving the product unattended.

Safety instructions

Operational safety and safety devices

Guidelines for safe operation and checks for product safety features.

Operation guidelines

Starting conditions, pedals, and parking brake

Conditions for starting, checks for pedals, and parking brake function.

Component descriptions and slope cutting

Information on muffler, protective covers and advice on cutting grass on slopes.

Operation guidelines

Slope operation, tow safety, and fuel safety

Guidance for slopes, towing, and critical safety measures for fuel handling.

Safety and assembly preparation

Transport, battery, and maintenance safety

Safety precautions for transport, battery, and maintenance procedures.

Assembly

Assembly overview and steering wheel installation

Visual guide for assembly and steps to install the steering wheel.

Throttle knob installation

Instructions for installing the knob on the throttle control lever.

Assembly

Seat adjustment, tow bar, and battery connection

Procedures for seat adjustment, tow bar installation, and battery connection.

Operation

Introduction, Husqvarna Connect, and fueling

General operation intro, app setup, and fuel filling instructions.

Pre-operation checks

Essential checks for engine oil level, fuel, and shut-off valve before starting.

Operation

Starting the engine, drive system, and parking brake

Step-by-step guide to starting the engine and operating drive and brake systems.

Operation

Cutting deck engagement and height adjustment

Instructions for engaging the cutting deck and setting the cutting height for TS 112/114 models.

Operation

Operating the product, reverse system, and stopping

How to drive the tractor, use the reverse system, and stop the engine.

Achieving a good cutting result

Tips for obtaining the best grass cutting performance.

Maintenance

Maintenance schedule overview

A table detailing required maintenance checks and their frequency.

Maintenance

Lubrication and cleaning procedures

Guidance on lubricating components and cleaning the product and its parts.

Maintenance

Cleaning specific parts and checking brake

Procedures for cleaning air intake, engine cover, fan, and checking the parking brake.

Replacing the fuel filter

Step-by-step instructions for replacing the fuel filter.

Maintenance

Air filter and spark plug maintenance

How to clean/replace air filter and examine/replace spark plug.

Maintenance

Fuse, battery charging, and emergency start

Procedures for fuse replacement, battery charging, and emergency engine start.

Connecting jumper cables

Steps for safely connecting jumper cables for an emergency start.

Maintenance

Battery replacement and cutting deck removal

Procedures for replacing the battery and initial steps for cutting deck removal.

Maintenance

Removing and installing the cutting deck

Detailed steps for removing and installing the cutting deck assembly.

Maintenance

Adjusting cutting deck parallelism and examining blades

How to adjust deck levelness and check blade condition.

Maintenance

Replacing blades, deck belt, and anti-scalp wheels

Instructions for replacing blades, deck belt, and adjusting anti-scalp wheels.

Maintenance

Checking engine oil level

Procedure for checking the engine oil level using the dipstick.

Replacing engine oil

Steps for draining old engine oil and refilling with new oil.

Maintenance

Replacing the oil filter

Instructions for replacing the oil filter on the TS 114 model.

Troubleshooting

Engine does not start

Common causes and solutions when the engine fails to start.

Troubleshooting

Engine running issues

Diagnosing and resolving problems with engine smoothness or overheating.

Troubleshooting

Power, vibration, charging, and OPC issues

Solutions for power loss, vibration, charging, and operator presence control problems.

Troubleshooting

Blade, discharge, and headlight issues

Addressing problems with blades, grass discharge, and headlights.

Troubleshooting

Slow movement, cutting results, and engine stopping

Solutions for slow operation, poor cutting, and engine stopping issues.

Transportation safety

Guidelines for safely transporting the product.

Transportation, storage, and disposal

Securing for transport and storage preparation

Instructions for securing the product for transport and preparing it for storage.

Transportation, storage, and disposal

Final storage steps and disposal guidelines

Final storage procedures and how to properly dispose of the product and chemicals.

Technical data

Dimensions and engine specifications

Key physical dimensions, engine output, and performance data for TS 112/114.

Technical data

Oil, electrical, cutting deck, noise, and vibration data

Details on oil, electrical system, cutting deck, noise, and vibration levels.

Service

Recommended service checks and spare parts

Advice on yearly servicing and ordering genuine spare parts.

EU Declaration of Conformity

EU directives and standards compliance

Statement of compliance with relevant EU directives and applied standards for the product.

UK Declaration of Conformity

UK regulations and standards compliance

Statement of compliance with relevant UK regulations and applied standards for the product.

Husqvarna TS 112 User Manual

Table of Contents

Questions and Answers:

Husqvarna TS 112 Specifications

Summary

Introduction

Pre-delivery inspection and product numbers

Product description and intended use

Insurance advice

Product overview (TS 112)

Control panel overview

Product overview (TS 114)

Control panel overview

Operator Presence Control and work light

Symbols on the product

Safety and operational symbols

Product safety labels and warnings

Product liability and danger labels

Safety instructions

Safety definitions and general instructions

Safety instructions

Safety regarding children and unsupervised operation

Safety instructions

Operational safety and safety devices

Operation guidelines

Starting conditions, pedals, and parking brake

Component descriptions and slope cutting

Operation guidelines

Slope operation, tow safety, and fuel safety

Safety and assembly preparation

Transport, battery, and maintenance safety

Assembly

Assembly overview and steering wheel installation

Throttle knob installation

Assembly

Seat adjustment, tow bar, and battery connection

Operation

Introduction, Husqvarna Connect, and fueling

Pre-operation checks

Operation

Starting the engine, drive system, and parking brake

Operation

Cutting deck engagement and height adjustment

Operation

Operating the product, reverse system, and stopping

Achieving a good cutting result

Maintenance

Maintenance schedule overview

Maintenance

Lubrication and cleaning procedures

Maintenance

Cleaning specific parts and checking brake

Replacing the fuel filter

Maintenance

Air filter and spark plug maintenance

Maintenance

Fuse, battery charging, and emergency start

Connecting jumper cables

Maintenance

Battery replacement and cutting deck removal

Maintenance

Removing and installing the cutting deck

Maintenance

Adjusting cutting deck parallelism and examining blades

Maintenance

Replacing blades, deck belt, and anti-scalp wheels

Maintenance

Checking engine oil level

Replacing engine oil

Maintenance

Replacing the oil filter

Troubleshooting

Engine does not start

Troubleshooting

Engine running issues

Troubleshooting

Power, vibration, charging, and OPC issues

Troubleshooting

Blade, discharge, and headlight issues

Troubleshooting