What to do if my Husqvarna Dust Collector motor runs but there is no suction?
If the motor of your Husqvarna Dust Collector runs but there is no suction, start by checking if the hose is properly connected and connect it if it is not. Also, the hose might be blocked, so try cleaning it. Another potential cause is an activated floating device. In this case, inspect the water level and check the float for any damages.
What to do if Husqvarna Dust Collector motor stops immediately after starting?
If your Husqvarna Dust Collector's motor stops immediately after starting, it could be due to a wrong fuse. Ensure you connect to the correct fuse. Another possible reason is a shortcut in the cable or machine, in which case you should order service.
How to fix dust blowing from my Husqvarna Dust Collector motor?
If dust is blowing from the motor of your Husqvarna Dust Collector, it is likely due to a wrongly assembled or damaged filter system. Try adjusting or replacing the filters to resolve this issue.
General| Voltage | 220-240 V |
|---|---|
| Airflow | 3600 l/min |
| Tank volume | 70 l |
| Cord length | 7.5 m |
| Noise level | 72 dB(A) |
| Hose length | 2.5 m |
To Next Page