What causes unusual noises from my Husqvarna Vacuum Cleaner?
Unusual noises from your Husqvarna Vacuum Cleaner can be caused by several things: * Loose screws and nuts. Tighten all screws and nuts. * A fault with the bearings. Speak to an approved service agent. * A damaged air flow hatch. Check the air flow hatch and replace it if necessary. * A damaged HEPA filter (if equipped). Check the HEPA filter and replace it if necessary.
How to fix a Husqvarna Vacuum Cleaner that does not start?
If your Husqvarna Vacuum Cleaner doesn't start, check the power connections and the power source. Also, ensure that the isolation contactor is correctly connected and that the product is connected to a power source.
Why is my Husqvarna Vacuum Cleaner making unusual noises?
If your Husqvarna Vacuum Cleaner is making unusual noises, start by tightening all screws and nuts. Then, check the air flow hatch and the HEPA filter for any damage and replace if necessary. If the problem persists, it might be a fault with the bearings, in which case you should speak to an approved service agent.
What to do if the filter cleaning system on my Husqvarna DC 655 Vacuum Cleaner isn't working?
If the filter cleaning system of your Husqvarna Vacuum Cleaner isn't working correctly, it could be due to several reasons. First, check the pneumatic system for sufficient pressure. If there's too much moisture in the pressure tank, remove it. If these steps don't resolve the issue, the Programmable Logic Controller (PLC) might be malfunctioning, and you should speak to an approved service agent.
How to stop dust from coming out of my Husqvarna DC 655 Vacuum Cleaner?
If dust is coming out of the air flow hatch of your Husqvarna Vacuum Cleaner, the primary filters might be damaged or incorrectly installed. Check the primary filters and replace them if necessary.
What to do if my Husqvarna Vacuum Cleaner indicates phase loss/open load?
If your Husqvarna Vacuum Cleaner indicates a phase loss or open load, confirm that all three phases are present, as one or two phases could be missing.
Why is the indicator for phase sequence control on my Husqvarna Vacuum Cleaner?
If the phase sequence control indicator is on for your Husqvarna Vacuum Cleaner, the phases are incorrect. Change the phase sequence.
What to do if my Husqvarna Vacuum Cleaner is over temperature?
If your Husqvarna Vacuum Cleaner is overheating, let the product become cool.
What does phase loss mean on my Husqvarna DC 655 Vacuum Cleaner?
To solve phase loss/open load issue for your Husqvarna Vacuum Cleaner, confirm that 3 phases are present, as 1 or 2 phases could be missing.
What should I do if my Husqvarna DC 655 Vacuum Cleaner overheats?
If your Husqvarna Vacuum Cleaner is experiencing an over temperature issue, let the product become cool.
General| Brand | Husqvarna |
|---|---|
| Model | DC 655 |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page