What does phase loss mean on my Husqvarna DC 655 Vacuum Cleaner?
To solve phase loss/open load issue for your Husqvarna Vacuum Cleaner, confirm that 3 phases are present, as 1 or 2 phases could be missing.
Why is my Husqvarna DC 655 Vacuum Cleaner motor on but there is no suction?
If the motor of your Husqvarna Vacuum Cleaner is running but there's no suction, the primary filters might be dirty, so you should clean them or replace them if necessary. Also, check the dust storage system, the dust extraction hose, and the tension of the V-belt for any issues like leakages, incorrect installation or damage. Replace any parts if needed.
What should I do if my Husqvarna DC 655 Vacuum Cleaner overheats?
If your Husqvarna Vacuum Cleaner is experiencing an over temperature issue, let the product become cool.
What to do if my Husqvarna DC 655 is showing an overload error?
To address an overload issue with your Husqvarna Vacuum Cleaner, find the cause for the overload, then push the reset button to reset the system.
How do I fix the phase sequence control indicator on my Husqvarna Vacuum Cleaner?
If the indicator for phase sequence control is on for your Husqvarna Vacuum Cleaner, the phases are incorrect. Change the phase sequence.
Why does my Husqvarna Vacuum Cleaner have no pressure in the pressure tank?
If there is no pressure or not sufficient pressure in the pressure tank of your Husqvarna Vacuum Cleaner, do a check of the pneumatic system. Also, the compressor filters might be dirty, so you should clean them.
What causes low pressure in the Husqvarna DC 655 Vacuum Cleaner pressure tank?
If the pressure in the pressure tank of your Husqvarna Vacuum Cleaner is less than 7 bar, the filter for the water separator or the filters for the compressor might be dirty or damaged, so you should clean or replace them. If the issue persists, there might be a leakage in the tubes or the control valve could be damaged, in which case you should speak to an approved service agent.
How to stop dust from coming out of my Husqvarna DC 655 Vacuum Cleaner?
If dust is coming out of the air flow hatch of your Husqvarna Vacuum Cleaner, the primary filters might be damaged or incorrectly installed. Check the primary filters and replace them if necessary.
What to do if the filter cleaning system on my Husqvarna DC 655 Vacuum Cleaner isn't working?
If the filter cleaning system of your Husqvarna Vacuum Cleaner isn't working correctly, it could be due to several reasons. First, check the pneumatic system for sufficient pressure. If there's too much moisture in the pressure tank, remove it. If these steps don't resolve the issue, the Programmable Logic Controller (PLC) might be malfunctioning, and you should speak to an approved service agent.
Why is my Husqvarna Vacuum Cleaner making unusual noises?
If your Husqvarna Vacuum Cleaner is making unusual noises, start by tightening all screws and nuts. Then, check the air flow hatch and the HEPA filter for any damage and replace if necessary. If the problem persists, it might be a fault with the bearings, in which case you should speak to an approved service agent.
General| Brand | Husqvarna |
|---|---|
| Model | DC 655 |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page