Husqvarna DE 110 H - User Manual

Questions and Answers

M
Mia PriceAug 20, 2025
Why won't my Husqvarna Vacuum Cleaner motor start?
- E
  Eric ScottAug 20, 2025
  If the motor of your Husqvarna Vacuum Cleaner stops immediately after starting or doesn't start at all, several factors could be at play. First, ensure the vacuum is properly connected to a power supply. If the power cord is damaged, or there's a short circuit within the unit, it's best to have an approved service agent handle the repairs. For DE 110 H/DE 120 H models, check that the HEPA filter is correctly installed and not damaged; replace or install it as needed. Also, verify that you're using the correct power supply and that the ambient temperature is within the specified range for operation. Finally, if the fan is broken or disconnected, have it repaired by an approved service agent.
D
Daniel BellAug 22, 2025
Why is the suction weak on my Husqvarna DE 110 H?
- D
  Dr. Noah LeeAug 22, 2025
  If your Husqvarna Vacuum Cleaner's suction is not sufficient, there are several potential causes. Ensure that you are using the correct power supply. Check the dust extraction hose for any holes and replace it if necessary. Also, the prefilter might be clogged; remove any dust particles from it, and clean or replace it if needed. A clogged HEPA filter can also cause this issue, so replace it if necessary. Make sure that the top cover is fully closed and that the seals are intact; replace the seals if they are broken.
A
andre65Aug 25, 2025
What to do if the red light is on on my Husqvarna Vacuum Cleaner?
- J
  Joanna DanielsAug 25, 2025
  If the red light comes on your Husqvarna Vacuum Cleaner, it could be due to several reasons. The HEPA filter might be missing, full, or damaged, so install it if it's missing and check to see if it needs replacement. The control unit could also be damaged, in which case you should let an approved service agent repair the product. High ambient temperature can also trigger the red light, so ensure you are using the vacuum within its specified temperature range.
M
mejiatraceyAug 26, 2025
What does it mean when the buzzer sounds and the red light is on on my Husqvarna DE 110 H?
- K
  Kevin MasonAug 26, 2025
  If your Husqvarna Vacuum Cleaner emits a buzzer signal and the red light comes on, it often indicates that the prefilter is clogged. Perform a filter purge procedure to remove dust particles from the prefilter. Also, ensure that the correct hose is connected and selected in the control panel. If the hose is damaged, compressed, or clogged, replace or clear it as necessary.
D
David GeorgeAug 28, 2025
How to stop my Husqvarna DE 110 H from releasing dust into the air?
- A
  Alexandra YoungAug 28, 2025
  If dust is being released into the air from the motor of your Husqvarna Vacuum Cleaner, it's likely that the filters are either incorrectly installed or damaged. Make sure to install the filters correctly, and replace any damaged filters.
C
Christopher MurrayAug 30, 2025
What does the yellow light mean on my Husqvarna Vacuum Cleaner?
- T
  Traci GatesAug 30, 2025
  A yellow light on your Husqvarna Vacuum Cleaner indicates that the HEPA filter is almost full. Consider replacing the HEPA filter if necessary.
L
linda46Sep 1, 2025
What does error code 2 mean on my Husqvarna Vacuum Cleaner?
- D
  Darren ThomasSep 1, 2025
  If your Husqvarna Vacuum Cleaner displays error code 2 indicating a missing HEPA filter, it means the HEPA filter is either missing or damaged. Assemble or replace the HEPA filter to resolve this issue.
B
Bianca SimsSep 3, 2025
What does error code 3 mean on my Husqvarna DE 110 H?
- T
  Theresa MendezSep 3, 2025
  If your Husqvarna Vacuum Cleaner displays error code 3, it indicates a low supply voltage. Ensure that you are using the correct grid/power supply.
M
Matthew MirandaSep 5, 2025
What does error code 4 mean on my Husqvarna Vacuum Cleaner?
- R
  rachelallisonSep 5, 2025
  If your Husqvarna Vacuum Cleaner displays error code 4, it indicates a high supply voltage. Make sure you are using the correct grid/power supply. If applicable, ensure the correct battery is being used.
G
Gilbert DavisSep 7, 2025
What does error code 6 mean on my Husqvarna DE 110 H Vacuum Cleaner?
- G
  gsanchezSep 7, 2025
  If your Husqvarna Vacuum Cleaner displays error code 6, it means the PCBA temperature is too high. Avoid using the product outside the specified temperature range.