sure that the cable can move smoothly into
the opening of the helmet.
To assemble the earmuffs to the helmet H300
1. Release the head harness from the helmet.
2. Attach the cable to the holes with the cable ties or
clips.
3. If you attach the cable with cable ties, cut the cable
tie and push the cable tie lock into the side slot.
4. Make a loop of the cable and attach the head
harness and neck protection. Make sure that the
cable is between the helmet shell and the head
harness.
To assemble the earmuffs to the helmet Spire
Vent X
1. Put the cable in a loop rearward.
2. Attach the cable to the head harness with cable ties.
Attach the cable tie through the backstrap of the
headband.
3. Cut the cable tie.
4. Put the remaining part of the cable in a loop
rearward, behind the rear headband.
To put the earmuffs in operation position
1. Put the helmet on your head.
2. Adjust the earmuffs until they are tight around your
ears and tight against your head.
6
2146 - 003 -
To Next Page
Loading...