Husqvarna YTA24V48 - User Manual

Questions and Answers

D
david40Aug 20, 2025
How to troubleshoot why my Husqvarna YTA24V48 will not start?
- M
  Maurice BaileyAug 20, 2025
  If your Husqvarna Lawn Mower won't start, several factors could be at play. First, ensure the fuel tank is adequately filled. If the engine isn't choked correctly, consult the “TO START ENGINE” section in the Operation manual. If the engine is flooded, wait a few minutes before trying again. Other potential issues include a bad spark plug (replace it), a dirty air filter (clean or replace it), a dirty fuel filter (replace it), water in the fuel (empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter), loose or damaged wiring (check all wiring), or engine valves that need adjustment (contact an authorized service center/department).
M
mendozajonathanAug 22, 2025
Why is my Husqvarna YTA24V48 Lawn Mower hard to start?
- S
  Stacie SullivanAug 22, 2025
  If your Husqvarna Lawn Mower is hard to start, consider these possible causes: a dirty air filter (clean or replace it), a bad spark plug (replace it), a weak or dead battery (recharge or replace it), a dirty fuel filter (replace it), stale or dirty fuel (empty the fuel tank and refill with fresh, clean gas), loose or damaged wiring (check all wiring), or engine valves that need adjustment (contact an authorized service center/department).
L
Lisa TylerAug 25, 2025
Why does my Husqvarna Lawn Mower engine click but not start?
- D
  Danny BrownAug 25, 2025
  If the engine of your Husqvarna Lawn Mower clicks but doesn't start, the issue might stem from a weak or dead battery (recharge or replace it), corroded battery terminals (clean them), loose or damaged wiring (check all wiring), or a faulty solenoid or starter (check/replace the solenoid or starter).
S
Sandra MillerAug 26, 2025
What causes the engine of my Husqvarna YTA24V48 to not turn over?
- E
  Edward DuarteAug 26, 2025
  If your Husqvarna Lawn Mower engine will not turn over, make sure the brake pedal is depressed. Also, ensure the attachment clutch is disengaged. Other possible causes include a weak or dead battery (recharge or replace it), a blown fuse (replace it), corroded battery terminals (clean them), loose or damaged wiring (check all wiring), a faulty ignition switch (check/replace it), a faulty solenoid or starter (check/replace them), or faulty operator presence switch(es) (contact an authorized service center/department).
M
Mark KingAug 27, 2025
What to do if the battery of my Husqvarna YTA24V48 Lawn Mower will not charge?
- S
  samuel46Aug 28, 2025
  If the battery of your Husqvarna Lawn Mower will not charge, it could be due to bad battery cell(s) (replace the battery), poor cable connections (check/clean all connections), a faulty regulator (if equipped, replace the regulator), or a faulty alternator (replace the alternator).
D
Duane DeanAug 29, 2025
How to prevent my Husqvarna YTA24V48 Lawn Mower engine from backfiring?
- H
  haguilarAug 30, 2025
  To prevent your Husqvarna Lawn Mower engine from backfiring when turning it “OFF”, move the throttle control between half and full speed (fast) position before stopping the engine.
J
Jordan RamirezSep 3, 2025
What to do if mower blades of my Husqvarna YTA24V48 will not rotate?
- C
  Carol JonesSep 3, 2025
  If the mower blades of your Husqvarna Lawn Mower will not rotate, there might be an obstruction in the clutch mechanism (remove the obstruction), a worn or damaged mower drive belt (replace the mower drive belt), a frozen idler pulley (replace the idler pulley), or a frozen blade mandrel (replace the blade mandrel).
M
marycrawfordSep 7, 2025
Why does my Husqvarna YTA24V48 Lawn Mower have a poor cut that is uneven?
- M
  Megan ValdezSep 7, 2025
  If your Husqvarna Lawn Mower provides a poor and uneven cut, inspect for a worn, bent, or loose blade (replace the blade and tighten the blade bolt). It may also be caused by the mower deck not being level (level the mower deck), a buildup of grass, leaves, or trash under the mower (clean the underside of the mower housing), a bent blade mandrel (replace the blade mandrel), or clogged mower deck vent holes (clean around mandrels to open vent holes).
G
gary17Sep 9, 2025
Why is there a loss of drive in my Husqvarna YTA24V48 Lawn Mower?
- B
  Brady ManningSep 9, 2025
  If your Husqvarna Lawn Mower experiences a loss of drive, first ensure the freewheel control is not in the “disengaged” position; place it in the “engaged” position. Other potential causes include debris on the steering plate (if equipped, see "CLEANING" in the Maintenance section), a worn, damaged, or broken motion drive belt (replace the motion drive belt), air trapped in the transmission during shipment or servicing (purge the transmission), or a missing axle key (install axle key at rear wheel; see "TO REMOVE WHEEL" in the Service and Adjustments section).
B
Brittany GreerSep 12, 2025
Why does my Husqvarna Lawn Mower have excessive vibration?
- K
  kjonesSep 12, 2025
  If your Husqvarna Lawn Mower has excessive vibration, check for a worn, bent, or loose blade (replace the blade and tighten the blade bolt). A bent blade mandrel (replace the blade mandrel) or loose/damaged parts (tighten loose parts and replace damaged parts) could also be the cause.

Husqvarna YTA24V48 Specifications

General

Engine Power	24 hp
Cutting Width	48 inches
Transmission Type	Hydrostatic
Fuel Type	Gasoline
Deck Material	Steel
Engine	Briggs & Stratton
Cylinders	2
Fuel Tank Capacity	3 gallons
Cutting Height, min	1.5 inches
Cutting Height, max	4 inches
Transmission Manufacturer	Hydro-Gear
Front Tire Size	15x6-6
Rear Tire Size	20x8-8
Turning Radius	16 in
Blade Engagement	Electric PTO