Husqvarna YTA20V46 User Manual (English)

Questions and Answers:

B
Brandy LeeAug 20, 2025
Why my Husqvarna Lawn Mower will not start?
- M
  Michael ClarkAug 20, 2025
  If your Husqvarna Lawn Mower won't start, several factors could be the cause. It might be out of fuel, so try filling the fuel tank. The engine might not be choked properly, refer to the “TO START ENGINE” section in the Operation manual. It's also possible the engine is flooded; if so, wait several minutes before trying again. Other potential issues include a bad spark plug (replace it), a dirty air filter (clean or replace it), a dirty fuel filter (replace it), or water in the fuel (empty the tank and carburetor, refill with fresh gasoline, and replace the fuel filter). Also check for loose or damaged wiring. If none of these steps work, the engine valves may be out of adjustment, requiring you to contact an authorized service center.
J
Joel AlexanderAug 22, 2025
What to do if Husqvarna YTA20V46 Lawn Mower engine will not turn over?
- M
  Matthew BrownAug 22, 2025
  If the engine of your Husqvarna Lawn Mower won't turn over, make sure the brake pedal is depressed. Also, check that the attachment clutch is disengaged. A weak or dead battery could also be the problem, so recharge or replace it. Look for a blown fuse and replace it if necessary. Clean any corrosion from the battery terminals. Inspect for loose or damaged wiring. If these steps don't work, the ignition switch, solenoid, or starter might be faulty and need checking or replacing. If the problem persists, there might be faulty operator presence switch(es), in which case you should contact an authorized service center.
A
Ashley HallAug 25, 2025
Why Husqvarna YTA20V46 Lawn Mower has poor cut - uneven?
- J
  Joshua SmithAug 25, 2025
  An uneven cut from your Husqvarna Lawn Mower can be caused by a worn, bent, or loose blade, so replace the blade and tighten the blade bolt. The mower deck might not be level, so level it. Buildup of grass, leaves, or trash under the mower can also cause an uneven cut, so clean the underside of the mower housing. A bent blade mandrel should be replaced. Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels can also lead to this issue, so clean around mandrels to open vent holes.
C
Charles ThompsonAug 26, 2025
What to do if Husqvarna Lawn Mower battery will not charge?
- M
  Molly BryantAug 26, 2025
  If the battery of your Husqvarna Lawn Mower will not charge, it could be due to bad battery cells, so replace the battery. Check and clean all cable connections to ensure they are secure. A faulty regulator (if equipped) or a faulty alternator could also be the cause, requiring replacement.
M
Melissa QuinnAug 28, 2025
Why Husqvarna YTA20V46 Lawn Mower engine backfires when turning engine off?
- D
  David TurnerAug 28, 2025
  If your Husqvarna Lawn Mower engine backfires when turning it off, make sure the engine throttle control is set between half and full speed (fast) position before stopping the engine.
R
Robert BrewerAug 30, 2025
How to fix a hard to start Husqvarna Lawn Mower?
- A
  Amy EstesAug 30, 2025
  If your Husqvarna Lawn Mower is hard to start, consider these possibilities: a dirty air filter (clean or replace it), a bad spark plug (replace it), a weak or dead battery (recharge or replace it), a dirty fuel filter (replace it), or stale or dirty fuel (empty the fuel tank and refill it with fresh, clean gas). Also, check for loose or damaged wiring. If these steps don't resolve the issue, the engine valves may be out of adjustment, and you should contact an authorized service center.
K
kellyrobertSep 5, 2025
What to do if Husqvarna YTA20V46 Lawn Mower engine clicks but will not start?
- K
  kevin46Sep 5, 2025
  If your Husqvarna Lawn Mower engine clicks but doesn't start, the problem could be a weak or dead battery, so recharge or replace it. Corroded battery terminals can also cause this issue, so clean them. Check for loose or damaged wiring. If these steps don't resolve the problem, the solenoid or starter might be faulty and need checking or replacing.
W
william44Sep 7, 2025
Why my Husqvarna Lawn Mower has excessive vibration?
- G
  gonzalezmicheleSep 7, 2025
  If your Husqvarna Lawn Mower is experiencing excessive vibration, the cause could be a worn, bent, or loose blade, so replace the blade and tighten the blade bolt. It might also be due to a bent blade mandrel, which would need replacing. Additionally, check for any loose or damaged parts, and tighten or replace them as needed.
J
Justin CastroSep 9, 2025
What causes Husqvarna YTA20V46 Lawn Mower blades will not rotate?
- N
  nknightSep 9, 2025
  If the mower blades of your Husqvarna Lawn Mower will not rotate, there could be an obstruction in the clutch mechanism, so remove it. The mower drive belt might be worn or damaged and need replacement. Alternatively, the idler pulley or blade mandrel could be frozen and need replacing.
R
Richard BernardSep 12, 2025
How to fix headlights not working on Husqvarna YTA20V46 Lawn Mower?
- S
  Stephanie RobertsSep 12, 2025
  If the headlight(s) on your Husqvarna Lawn Mower aren't working, first check if the switch is “OFF” and turn it “ON”. If that's not the issue, the bulb(s) or lamp(s) might be burned out, so replace them. A faulty light switch could also be the problem, so check or replace it. Inspect the wiring and connections for any looseness or damage. Finally, check for a blown fuse and replace it if necessary.

Husqvarna YTA20V46 Specifications

General

Engine	Briggs & Stratton
Engine Power	20 HP
Cylinders	2
Cutting Width	46 inches
Transmission Type	Hydrostatic
Cutting Height, min	1.5 inches
Cutting Height, max	4 inches
Deck Material	Steel
Weight	500 lbs
Blade Engagement	Electric
Turning Radius	18 inches
Speed Range	0 - 5.5 mph
Fuel Capacity	2.5 gallons
Tire Size, front	15x6-6