EasyManua.ls Logo

Hussmann KRACK MK34 315 Series - User Manual

Hussmann KRACK MK34 315 Series
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MK/MV-Medium Profile Series Unit Coolers (E206993_J)
Part Number: E206993_M

Table of Contents

Questions and Answers

  • J
    Jasmine ThomasAug 9, 2025
    What to do if fans will not operate in Hussmann KRACK MK34 315?
    • S
      Steven PhillipsAug 9, 2025
      If the fans in your Hussmann Cooling boxes aren't working, there could be several reasons. First, check the wiring to ensure the unit is properly connected. If the wiring is correct, the motor might be defective and need replacement. Another possibility is a defective defrost timer, termination thermostat, or fan delay switch, in which case you should replace the faulty component. Also, if the room temperature is too high for the fan delay switch, try jumpering the fan delay switch terminals F to B.
  • C
    Craig YorkAug 17, 2025
    Why is ice forming on the ceiling of my Hussmann KRACK MK34 315 Cooling boxes?
    • L
      Linda ThompsonAug 17, 2025
      Ice forming on the ceiling of your Hussmann Cooling boxes can occur for a couple of reasons. One reason is that there are too many defrost cycles happening each day. To address this, observe the frost buildup on the coil and adjust the timer to reduce the number of defrost cycles per day. Another cause could be a defective termination thermostat or defrost timer, which would require replacing the defective component.
  • B
    Bonnie EricksonAug 25, 2025
    What to do if there is excessive buildup of frost on the coil in Hussmann Cooling boxes?
    • T
      teresa68Aug 25, 2025
      Excessive frost buildup on the coil in your Hussmann Cooling boxes can be due to a few reasons. It could be that there are too few defrost times, in which case you should add more defrost cycles to the timer. Alternatively, the defrost cycle might be too short, so you should extend the defrost time on the timer. Also, high humidity in the cooler can cause this issue; try to limit access to the cooler and avoid propping doors open during stocking.
  • E
    Elizabeth SchmidtAug 31, 2025
    How to fix accumulation of ice in drain pan of Hussmann Cooling boxes?
    • N
      Nathan DixonAug 31, 2025
      If you notice ice accumulating in the drain pan of your Hussmann Cooling boxes, it's likely due to one of two issues. First, the drain line might be plugged, so try cleaning the drain line. If the drain line isn't the problem, the heater might be defective and require replacement.

Summary

BEFORE YOU BEGIN

Safety Definitions and Precautions

Covers PPE, DANGER, WARNING, CAUTION, NOTICE definitions, environmental concerns.

Critical Installation Safety

PIPING INSTALLATION AND COMPONENTS

Evacuation, Leak Testing, and Defrost Piping

ELECTRICAL SYSTEM REQUIREMENTS

Field Wiring and Electrical Data

Guidelines for field wiring, compliance with codes, and electrical data tables.

Electric Defrost Cycle Details

KE2 EVAP OEM CONTROLLER OPERATION

Controller Sequence of Operation

How the KE2 Evap OEM controller manages the system and defrost.

KE2 Defrost Operation Modes

ELECTRIC DEFROST OPERATION

CONNECTIVITY AND SMART ACCESS SETUP

SMART ACCESS WEB BROWSER INTERFACE

NETWORK SETUP AND SETPOINTS CONFIGURATION

MULTI-CONTROLLER SYSTEM OPERATION

START UP AND OPERATION CHECKOUT

Pre-Startup Checks

Checks to perform before placing the system into operation.

Operation Checkout and Adjustments

Verifying system functions and performing initial adjustments.

PREVENTATIVE MAINTENANCE AND TROUBLESHOOTING

KE2 EVAP CONTROLLER ALARM TROUBLESHOOTING

Superheat Alarms Troubleshooting

Troubleshooting high and low superheat alarms and related EEV issues.

REPLACEMENT PARTS LIST

Hussmann KRACK MK34 315 Series Specifications

General IconGeneral
BrandHussmann
ModelKRACK MK34 315 Series
CategoryCooling boxes
LanguageEnglish

Related product manuals