P/N 0387177_K
PARTS LIST
Item
Quantity Description
RL/RM RLN RLNI
RM/RMF RMN RLNIE RLT
1. 2 2 4 2 Donut Gasket
2. 1 1 2 2 Gasket, 1 x
1
/2 x 180 in.
3. 1 1 2 1 Gasket,
1
/2 x
1
/4 x 180 in.
4. 8 8 14 6 Cap Screw
5
/16 -18 x 1
1
/4
5. 8 8 14 6 Split Lock Washers
5
/16
6. 1 1 2 1 Joint Molding
7. 5 5 10 5 Binder Post and Screw
8. 1 1 2 1 Splice Connector
RL / RM / RMF, RLT
RLN / RMN / RLNI / RLNIE
Joining Instructions
Joining Instructions
NOTE: Be sure first merchandiser has been leveled
according to the main installation instruction.
Carefully unpack and inspect the joining parts listed
above to verify completeness and that there is no
damage.
1
Prepare cases for joining (both sides of
islands) as shown in Figure 1.
A. Remove bumpers, rails, packing materials,
and splashguards from the both cases.
B. Remove shelves (if installed).
C. Remove display racks and pans from
ends to be joined.
D. Remove rear shelf supports.
Splashguard brackets must
be installed before piping or
wiring case.
B
A
C
D
E
C
Figure 1. Prepare Cases
A
Bum per
Bum per
Retainer
Splashguard
SIDE VIEW
A
RLT
Bumper
Bumper
Retainer
Splashguard
SIDE VIEW
MANUAL- KIT REACH-IN JOINING
To Next Page
Need help?
General
