HUST CNC H6D-T Manual
1 - 2
Program Designed by CAD/CAM on PC. Program input from PC through RS232C
interface.
Based on varied characteristics of CNC models, the MCM Parameter Setting Table
can be used to set the mechanical parameters for enhancing the amiability of the
machine.
Using the well-based Tool management function, the customer can set up 40-tool
lifespan management and select the desired operation count, time limit.
Provide 40 sets of tool-length offsets.
It is equipped with gear gap compensation function for adjusting the gear gap error
after using the Guide Stud. Further, it also has 40-section pitch compensation
function to offset the pitch wearing in different sections.
It is provided with 6 sets of working coordinate system setting functions to facilitate
the program design and Workpiece machining.
Full follow-up type of tapping mode in achieving more perfect thread, more
accurate thread depth control and faster speed.
Each axis can be set as active, passive mode or single-node non-stop mode.
It is equipped with gear gap compensation function for adjusting the gear gap error
after using the Guide Stud. Further, it also has the 40-section pitch compensation
function to offset the pitch wearing in different sections.
It is provided with 6 sets of working coordinate system setting functions to facilitate
the program design and Workpiece machining.
Full follow-up type of tapping mode in achieving more perfect thread, more
accurate thread depth control and faster speed.
Each axis can be set as active, passive mode or single-node non-stop mode.
To Next Page
Loading...
Need help?
General
