HUST CNC H6D-T - Page 172

HUST CNC H6D-T Manual
3 - 110
2. Range of angle: 00.36000.360 , for an angle exceeding the 360.00 range,
divide the angle by 360.00 degrees and take the remainder. E.g., for an angle of
400.00 degrees, the remainder 40.00 after divided by 360.00 will be the specified
angle.
3. Report an error if relative coordinates are used for the end coordinates of the
second block.
4. Report an error if the two lines have no any intersection point, or the intersection
angle is less than 1 degree.
Other relevant functions:
1. Specify a chamfer or round-angle chamfer only when the angle of the first block is
specified.
EX1
N1 G01 ,Aa1 Cc1
N2 G01 Xx2 Zz2,Aa2
EX2
N1 G01 ,Aa1 Rr1
N2 G01 Xx2 Zz2,Aa2
Fig. 3-95
EX1 EX2