HUST CNC H6D-T - Page 181

4 MCM Parameter Settings
4 - 5
4.2 Description of Parameters
(1) Basic Parameters
* For the cutting parameters of G71-G76, please refer to the description of
respective G-Code command under G/M Code of Chapter 3.
1. Set rilling Cycle uffering istance
Format  . default value: .
 hen using 3 drilling command, the corresponding ais will move uickly
from  for converting to the buffering distance setting of 1 feeding.
2.
The ratio of the horiontal ais  ais in graph mode
Format .
This parameter is for setting the scale of the graph in the graph mode.
This parameter is an initial setting; for dynamic adustment, you may press
PageUP/Pageown button in the graph screen for alteration.
3.
Initial alue generated by line number during program editing
Format  default value: 
 hen editing the program, the line number set for the first node system shall be
"1". If setting the parameter of this item as "1", then the line number of the
second node will be "1".
4.
The interval value obtained from setting the line number during program editing.
Format  default value: 
5. Setting the chuck movement inner, outer clamp setting
Format  default value: 
Setting , loosen
Setting 1, tighten