UST CC 6-T Manual
4 - 6
This parameter is for specifying whether the chuck is loosened or tightened in a
protruding action.
6. orking Count Upper imit Setting
Format default value:
ignored.
To eecute the count, please add M15 in the working program placed at the end
of each processed orkpiece.
If receiving M15 Command when running the program, the system will add "1" to
the number of the processed orkpieces automatically. Upon reaching the upper
limit set for the orkpiece, the System will change to pausing status, reminding
the customer that it has completed the set working count.
After reaching the upper limit count, the count arriving status can be cancelled by
the following three methods:
a.
set to ero.
b. Restart the program. ou may also clear and set the worked count ero in order
to restart the counting.
c. Press the Reset key and the count arriving status can also be cancelled and the
worked count will be set to ero.
7. Time delay for chuck tightening
Format default value: 5, unit:1ms
This parameter is set to ensure that the chuck is securely clamped on the
workpiece. In case the chuck fails to clamp the workpiece securely before
eecuting the subseuent block, the setting needs to be increased.
8. Remaining Service ays
Such parameter is provided for reading instead of writing.
To remind the user to contact the machine manufacturing when the remaining
service days are going to arrive.
To Next Page
Loading...