4 MCM Parameter Settings
4 - 7
9. hether or not wait for spindle to reach full speed before performing aial feed
Format default value:
Setting , proceed the subseuent block without waiting for the full speed of the
spindle
Setting 1, proceed with the subseuent block after the spindle reaches full speed
For general cutting commands, aial feed can be performed without waiting for
the full spindle speed; for threading and drilling commands, to meet the technical
criteria, it may demand the spindle to reach a steady speed before performing the
cutting, therefore this parameter shall be set to 1, i.e., proceed with the subseuent
block after the spindle reaches full speed
Setting this parameter to 1 affects the processing efficiency. Therefore the user
must consider and weigh the relationship between the technical criteria and
efficiency reuirements for setting a proper value.
10. Radius or diameter programming
Format efault
Setting , -ais is radius programming.
Setting 1, -ais is diameter programming.
Since general drawings indicate drills by its radius, setting this parameter to may
facilitate the programming process. The customer may alter this parameter
according to the actual reuirements, so as to enable an easy and direct way for
programming.
11. Manual Tool Change Rotation irection Setting:
Format default value:
Setting , it means C.
Setting 1, it means CC.
The Turret service parameters can be based to set the rotating direction when the
Turret is operated under Manual Mode.
Under Manual Mode, set this parameter to facility the site Tool change e.g. for
T1
To Next Page
Loading...