HUST CNC H6D-T - Page 184

UST CC 6-T Manual
4 - 
performing the C and CC Tool change, you may set this parameter.
12. Omission of decimal point in programming
Format  default value: 
Setting  , no omission of decimal point
Setting  1, decimal point omitted.
See 2.2.2.3 decimal point principles for details
13. If the Tool lifespan management function is active
Format  default value: 
Setting  , it means start.
Setting 1, it means close.
If the user sets stricter service life for all tools used, it is suggested that this
function should be activated in order to manage the tool and remind the timing for
Tool change. After activating such function, the program will stop at T-Code when
the Tool service time or the count is up.
14. Metric and imperial settings
Format  default value: 
Setting  , metric system unit: mm
Setting  1, imperial system unit: inch
Setting of the measurement unit 1inch  25.4 mm.  hen Setting  1, both the
coordinates and tool compensation are displayed to the 4
th
digit after the decimal
point.
15.  hether or not eecuting MTS 4 at a re-start
Format  default value: 
Setting  , skip
Setting  1, eecute
This setting allows the user to select whether an MST code or a 4 command
eisting before the re-start block shall be eecuted or not when the program
re-start function is enabled. The user may freely set this parameter based on actual
needs.