HUST CNC H6D-T - Page 185

4 MCM Parameter Settings
4 - 
S 4 command before the re-start block
will be omitted.
MTS 4 command before the re-start block
will be eecuted normally.
16.  hether a re-start skips M
Format  default value: 
Setting  , do not skip
Setting  1, skip
An M command call sub-program prior to the re-start block will be carried out
normally if this parameter is set to .
An M command call sub-program prior to the re-start block will not be carried
out if this parameter is set to 1.
17.  hether a re-start retrieves a prior block
Format  default value: 
Setting  , retrieve
Setting  1 no retrieve
Program goes to the block prior to the re-start block and eecutes
the prior block and the subseuent program.
the block prior to the re-start block.
18.  hether or not a smooth transit of tool-tip compensation is enabled
Format  default value: 
Setting  , yes
Setting  1, no
 hen 41, 42 function is enabled see 3.24.2, setting this parameter to 1 will
cause the tool-tip outside compensation to disable arc compensation and take a
line compensation.
19. Setting for handling interference concerning 41/42
Format  default value: 
Setting  , issue alarm without eecution