HUST CNC H6D-T - Page 186

UST CC 6-T Manual
4 - 1
Setting  1, automatically optimie trace to avoid interference
Setting  2, eecute without issuing an alarm
In case of interference during the tool-tip compensation command 41, 42, you
may set this parameter to select the handling method. See 3.24.2 for details of this
setting
(2) System Parameter
20. enominator of Machine Resolution, -ais.
21. umerator of Machine Resolution, -ais.
22. enominator of Machine Resolution, -ais.
23. umerator of Machine Resolution, -ais.
24. enominator of Machine Resolution, -ais.
25. umerator of Machine Resolution, -ais
The value of resolution numerator or denominator is set according to the
specification of Aial Transmission evice e.g. uide Screw and the pulse count
returned by the Servo Motor. enerally speaking, the speed voltage control type
is set according to the pulse count returned by the Servo Motor; whereas, the
position pulse control type is set by the pulse count after the Motor rotates for
one round. After being confirmed, do not attempt to adust unless instructed.
Speed Control Type
Position Control Type
Example 1 (Speed Control Type):
-ais uide Screw Pitch  5.mm
Motor ncoder  25 pulse; Multiple 4
Tooth Count Ratio 5:1 5 rounds for Servo Motor, 1 round for uide Screw
Resolution Tooth
uide Screw Pitch
Motor 1-round Pulse Count
Resolution Tooth Count Ratio
uide Screw Pitch
Motor ncoder Multiple