HUST CNC H6D-T - Page 187

4 MCM Parameter Settings
4 - 11
-ais Resolution: enominator Set alue  1
-ais Resolution: umerator Set alue  1
Example 2 (Position Control Type):
-ais uide Screw Pitch  5.mm
Motor 1-round Pulse  1 pulse
Tooth Count Ratio 5:1 5 rounds for Servo Motor, 1 round for uide Screw
-ais Resolution: enominator Set alue  1
-ais Resolution: umerator Set alue  1
26. Set ais traverse speed limit
Format Unit: mm/min efault1
ote : The format is only for integer.
The traverse speed limit can be calculated from the following euation:
Fma  .5  RPM  Pitch  R
RPM : The ratio. rpm of Servo Motor motor
Pitch : The pitch of the ball-screw
R : ear ratio of ball-screw/motor
: Ma. rpm  3 rpm for -ais, Pitch  5 mm/rev, ear Ratio  5/1
Fma  .5  3  5 / 5  25 mm/min
27. irection of Motor Rotation, -ais
28. irection of Motor Rotation, -ais
29. irection of Motor Rotation, -ais
Resolution
Resolution