HUST CNC H6D-T - Page 192

UST CC 6-T Manual
4 - 16
Fig. 4-11 : Machine OM Return Speed and Find ero RI irection
42. -ais ncoder Find ero-Point Ma. istance
43. -ais ncoder Find ero-Point Ma. istance
44. -ais ncoder Find ero-Point Ma. istance
Format default value: 1.; Unit: mm
Scope: .mm
Ma. distance limit for Servo Motor to find the rid signal.
ample: If the distance after -ais Servo Motor turns for 3/4 round is 5.mm,
then Parameter 42 will be 5.2.
Note: If the Servo Motor fails to find out the Grid point after exceeding the
set scope, then the system will display ERR 15 alarm message.
45. Software OT imit in  irection, -ais.
46. Software OT imit in  irection, -ais.
47. Software OT imit in  irection, -ais.
Format Unit: mm/min efault.
Set the software over-travel OT limit in the positive  direction, the setting
value is eual to the distance from positive OT location to the machine origin
OM.
48. Software OT imit in - irection, -ais.
49. Software OT imit in - irection, -ais.
50. Software OT imit in - irection, -ais.
Format . Unit: mm/min efault-.
Speed
Section-2
Section-3
Tool Position
Touch imit Switch
Find ero for ncoder
Speed: OM Return Speed 2
ncoder Find ero irection: 
eave imit Switch
Speed: OM Return Speed 1  1/4
ncoder Find ero irection: 
Section-1: OM
Return Speed