HUST CNC H6D-T - Page 193

4 MCM Parameter Settings
4 - 17
Set the software over-travel OT limit in the negative - direction, the setting
value is eual to the distance from negative OT location to the machine origin
OM.
Travel Limit Concept and Description:
Fig. 4-12
Note: The software travel limit setting point is approx. 5~10mm to EM-TOP.
51. -ais enominator, MP and-wheel Resolution Adustment. pulse
52. -ais umerator, MP and-wheel Resolution Adustment. m
53. -ais enominator, MP and-wheel Resolution Adustment. pulse
54. -ais umerator, MP and-wheel Resolution Adustment. m
55. -ais enominator, MP and-wheel Resolution Adustment. pulse
56. -ais umerator, MP and-wheel Resolution Adustment.  m
Format efault  1
ample: If Item 51 Parameter  1; Item 52 Parameter  1; and and  heel
Multiple is 1, then,
and  heel moving for 1 frame  1 Pulse
.1mm
57. Ma. value of U,  tool compensation can be entered during the operation
Format  . default value: 2., Ma. value is 2., unit: mm
M-TOP
Actual ardware imit
51mm each
51mm each
M-TOP
Machine Origin ome
Software OT imi
t