HUST CNC H6D-T - Page 194

UST CC 6-T Manual
4 - 1
Alteration of tool compensation data during the operation can only be made with
incremental method. This parameter is used to set a maimum value for
preventing tool collision.
Setting value ., denotes no alteration of tool compensation data during the
operation.
58. Pitch rror Compensation Mode Setting, -ais.
59. Pitch rror Compensation Mode Setting, -ais.
60. Pitch rror Compensation Mode Setting, -ais.
Format: , efault
Setting  , Compensation canceled.
Setting  -1, egative side of compensation.
Setting  1, Positive side of compensation.
ote: The screw offsetting will be allowed only one direction at a time.
-ais -ais -ais planation
  
Compensation cancel
-1 -1 -1
o compensation when tool is on the - side of the
reference point
1 1 1
o compensation when tool is on the  side of the
reference point.
61. Segment ength for Pitch rror Compensation, -ais
62. Segment ength for Pitch rror Compensation, -ais
63. Segment ength for Pitch rror Compensation, -ais
Format . , efault, Unitmm
Note: The offset value of each section will be entered by pressing “Screw
4-, 4-, 4-1.
The length setting scope of each section for offsetting the error of
screw pitch will be 24mm.
 hen the setting of offset length is below 2mm, then the length shall
be set at 2mm.
The offset setting means the incremental value, which cab epressed
either in positive or negative manner. If the offset section count is less