HUST CNC H6D-T - Page 195

4 MCM Parameter Settings
4 - 1
than 4 sections, then the parameter of the remaining sections must be
set at ero .
ample: Assuming the total length of the -ais screw is 1m 1mm, and
where it will be divided into 1 sections for offsetting:
Fig. 4-13
Therefore, the average length of each section is 1mm. It means that the set
in which, the offset of each section is set by parameter items as per Fig. 4-,
Section 11 and Section 114 must be set as ero.
64. Spindle type Re-start enabled
Format  default value: 
Setting  , oltage type spindle
Setting  1, Pulse type spindle
User may make corresponding settings according to the actual control of spindle.
65. Set oop Open/Close Control Method Restart avail
Format  default value: 
Setting  : Spindle open loop control.
Setting 1: Spindle closed loop control Spindle alignment control.
For the Spindle of oltage-type Servo Motor, such parameter can be set according
to the wiring method see 5-15, 5-16.
For the Spindle of Pulse-type Servo Motor, such parameter would be meaningless.
66. Set Spindle Acceleration/eceleration Time
Format
Setting Scope: 23 ms.
1 mm
1mm