UST CC 6-T Manual
4 - 34
3 or the
,
, 1
and 27
Closed Angle phenomenon on the cutting
surface of the orkpiece during round hole or cylindrical cutting for 2 or 3.
To offset the Closed Angle, the Controller will type out all the offset values
instantly after changing the direction within one offset cycle and then
compensate such offset value with straight-line acceleration/deceleration curve.
The said offset level and time constant will be determined by the aforesaid three
sets of parameters.
Forward Offset alue: ecute the offset when the ais returns from the reverse
action for moving towards the forward direction.
Reverse Offset alue: ecute the offset when the ais returns from the forward
action for moving towards the reverse direction.
Offset Time: The Controller will send out all of the offset values within the set
offset time. hen setting such parameter at ero, the system will compensate the
said offset within one acceleration/deceleration cycle.
The Arc Closed Angle offset function : Close; 1: Open is used to control the
availability of the aforesaid parameters.
140. 2 Thread Tail Retreating Acceleration/eceleration Time ms
Format default value: 1
hen the thread reaches the end point under the command of 2, such parameter
is used to set the acceleration/deceleration time when , aes are making fast
thread tail retreating.
141. hether or not to return to origin after -Stop
Format default value:
: es, Returning to origin after -Stop is necessary for activating the process.
1: o. Returning to origin after -Stop is not necessary for activating the process.
142. If to stop the Spindle after ending the program
Format default value:
: o
1: es
To Next Page
Loading...