4 MCM Parameter Settings
4 - 35
After activating the Spindle, if the working program does not eecute the Spindle
stop command before completing the program running, then such parameter can
be used to stop the Spindle.
The customer can eecute appropriate setting for such parameters according to the
operation habitude.
143. If to start Auto Program
Format default value:
: o
1: es
Such parameter is used to start the Semi-Auto/Auto function.
Semi-Auto Function: The program will end the working when receiving M2 or
M3.
Auto Function: The program will not end the working when receiving M2 or
M3 and will continue the loop to run the program.
144. ellow amp means Pause or Finish
Format default value:
: ellow lamp means the Pause reminding signal.
1: ellow lamp means the Finish reminding signal.
2: ellow lamp means the Finish as well as the Pause reminding signal.
145. Spindle-specific RPM when starting
Format default value: 1
Such parameter is used to set the Spindle-specific RPM when starting the machine
and when activating the Spindle manually or by M-Code before giving the S RPM
command.
146. 1/2/3 for round-angle connection
Format default value: 2
: Precision positioning without handling between 1/2/3 blocks
1: Round-angle connection between 2/3 blocks only
2: Round-angle connection between 1/2/3 blocks
To Next Page
Loading...