HUST CNC H6D-T - Page 212

UST CC 6-T Manual
4 - 36
User may set proper parameter values according to technical criteria of the
substantial product.
147. If to disconnect the power when receiving the Servo Motor alarm
Format  default value: 
: o need to disconnect the power of Servo Motor.
1: eed to disconnect the power of Servo Motor.
 hen the Servo Motor sends off an alarm, depending of varied reuirements of
the customer, the system can be set to disconnect the Main Circuit power of the
Servo Motor and to retain the control power only. After removing the alarm,
restore the Main Circuit power again.
signal.
If O5 is under OFF status when the Servo Motor sends off alarm, it means the
main power of such Servo Motor will be disconnected.
If O5 is under O status when the Servo Motor is working normally, it means the
main power of such Servo Motor will not be disconnected.
the Spindle Chuck type can be set through the “Spindle Chuck