HUST CNC H6D-T - Page 234

HUST CNC H6D-T Manual
5 - 22
5.6.5 I/O W iring
Structure of wiring (1)
All of the SIO board must used the same DC24V power supply except to the AC
output board.
Fig.5-26
15 pin Female to Male cable
HUST H6D CONTROLLER
40-pin Bull-horn harness; Group 2; CONNECT
Board port
I120~I43 (24in) O112~O127 (16out)
40-pin Bull-horn harness; Group 1; CONNECT
Board port
I96~I119(24in) O96~O111(16out)
24V Power Input 24V Power Input
24V Power In
p
u
t
TO-NEXT
I48/032
24V Power Input