2 Operation
2 - 13
5. After completing the copying, move the cursor to the position to be pasted and
then press “Paste” key to paste up the copied program block (as per Fig. 2-14).
The copied program block can be pasted to the other program designated by
program number and it can also be repeated pasted.
Fig. 2-14
(1) Restart Again; In the edit program, move to the node to be restarted with
key and then press “Set Restart”, and the node is the set restart node.
When the “Set Restart” indicates reverse white, it means such function is active.
(2) Interrupt Node: To search the interrupted node after the program is interrupted
during the working process (e.g. press Reset, emergency stop, shutdown), access
the Edit screen and then press “Interrupted Node” soft key and it can be retrieved.
(3) Search: To enter certain bit and value in the specific program node, press this key
and the cursor will skip to the corresponding node position. To repeat, press
“Search” key and the system will continue looking for the next bit that meets the
requirements.
For detailed operation of program editing, please refer to Program Edit section.