6 Error Message
6 - 15
* Count is Up
Message:
The working count of the Workpiece has reached the set count.
Remedy:
1. In Auto Display screen, briefly press 0 for twice and the working count will be
set to zero.
2. Execute M16 command.
3. Press Reset key.
4. Press Start key again.
* Hydraulic Station Unusual
Message:
The Hydraulic Station is working abnormally.
Remedy:
Check the working status of the Hydraulic Station.
* Oil Filler is abnormal.
Message:
The Oil Filler is working abnormally.
Remedy:
Check the working status of the Oil Filler.
* Please Start the Spindle First
Message:
If the Spindle stops running when the program is under pausing status, the System will
remind the operator to start the Spindle in order to cancel the pausing status for
resuming normal working process.
* Coolant Unusual
Message:
The Coolant Pump is working abnormally.
Remedy:
Check if the Coolant Pump is working normally.
To Next Page
Loading...