HUST CNC H6D-T - Page 266

HUST CNC H6D-T Manual
6 - 14
Functon Alarm:
* Motor has not returned to Home Position
Message:
The axis set by the user for returning to the Home Position has failed to return to the
Home Position.
Remedy:
Move the failed axis back to the Home Position
* Spindle Chuck is not Clamping Tightly
Message:
Remedy: If the Spindle Chuck is under loosening status, the Controller will send off
such alarm when starting the Spindle.
Remedy:
Under MDI Mode, clamp the Chuck tightly with M11 Command or press Manual
Chuck under Manual Mode to hold the Chuck tightly.
* Spindle Command Invalid
Message:
Remedy: If the Spindle Chuck is under loosening status, the Controller will send off
such alarm when giving the Spindle CW/CCW action command.
Remedy:
Clamp the Spindle Chuck first and then give the Spindle action command.
* Motor Unusual Signal
Message:
The Servo is operated abnormally.
Remedy:
Check the Motor running status and then remove the Motor alarm.
* Turret not Locked
Message:
When the Tool change is in position, the system fails to send off the Tool Pan locking
signal.
Remedy:
Check the working status of Tool Pan locking signal.
* Tool Change Monitoring Overdue
Message:
The time used by Tool change has exceeded the Tool change monitoring time.
Remedy:
Check if the Turret is running or if the Hydraulic Station is working normally. If yes,
adjust the parameters of Tool Change Monitor Time to a moderate range.
* Positionk Limit Alarm
Message:
The axis displacement has exceeded the hardware position limit.
Remedy:
Move the axis toward the opposite direction with Hand Wheel.