HUST CNC H6D-T Manual
7 - 48
Ex2: For Y-axis, MCM #743 = 200 pulses, MCM #744 = 500 m.
The resolution for Y-axis = 500/200 = 2.5 m/pulse.
If MPG hand-wheel moves 1 notch (=100 pulses), the feed length in Y-axis
= 100 x (500/200) = 250 m = 0.25 mm.
MCM# 759~780 System Reserved
781. Set if X-axis is rotational axis.
782. Set if Y-axis is rotational axis.
783. Set if Z-axis is rotational axis.
784. Set if A-axis is rotational axis.
785. Set if B-axis is rotational axis.
786. Set if C-axis is rotational axis.
787. Set if U-axis is rotational axis.
788. Set if V-axis is rotational axis.
789. Set if W-axis is rotational axis.
Format= (Default 0)
Setting= 0 Linear Axis
Setting= 1 Rotational Axis
MCM# 787~800 System Reserved
801. The distance of S bit sent before the X-axis reaches in position. (S176)
802. The distance of S bit sent before the Y-axis reaches in position. (S177)
803. The distance of S bit sent before the Z-axis reaches in position. (S178)
804. The distance of S bit sent before the A-axis reaches in position. (S179)
805. The distance of S bit sent before the B-axis reaches in position. (S180)
806. The distance of S bit sent before the C-axis reaches in position. (S181)
807. The distance of S bit sent before the U-axis reaches in position. (S182)
808. The distance of S bit sent before the V-axis reaches in position. (S183)
809. The distance of S bit sent before the W-axis reaches in position. (S184)
Format= . (Default= 0.000)
Unit: mm
For example: MCM 801 =10.00mm
Giving the command: When G01 U30.000 F1000, when the X-axis move
20.000mm and 10.000mm away from the final value, the sysem will send
S176=ON
MCM# 807~820 System Reserved
821. The accelerate/decelerate time of X-axis.
822. The accelerate/decelerate time of Y-axis.
823. The accelerate/decelerate time of Z-axis.
824. The accelerate/decelerate time of A-axis.
825. The accelerate/decelerate time of B-axis.
826. The accelerate/decelerate time of C-axis.
827. The accelerate/decelerate time of U-axis.
To Next Page
Loading...