9 Appendix B – PC On-line Operation
9 - 3
Fig 9-1
Note: If the transmission program has numbers, it will be stored as the same numbers as
in CNC after transmitting, otherwise, it will be replaced by its current program.
1. The HCON is used to Upload the program data onto the controller, and the
program data are stored on the memory cache (RAM).
2. When the controller turns the power off, the program data are stored on the memory
cache (RAM) via the battery mode.
3. To ensure permanent data storage on the memory cache (RAM), there is need to
execute the command G10 P600 L01 to store the Uploaded program data onto
the FLASHROM.
4. As depicted in Fig. 9-1, upon entering the G10 P600 L01 command in the entry
area, press MDIGo to complete the burn movement.
9.1.2 Program Transfer from CNC Controller to PC
Movement program:
1. The controller is not in a program execution status (where S080=0).
2. On PC side, make sure the transmission is ready to transmit.
Baud Rate should be correct when you execute HCON.exe (See section 10, Chapter
9 ). After entering Data Transmission Mode ( FileSvc ),
(1) Select “ Recv File fm CNC : TYPE >>> ”
To Next Page
Loading...