HUST CNC H6D-T - Page 328

HUST CNC H6D-T Manual
9 - 4
(2) Select “ 0:CNC ” to read the current program in the controller.
Select “ 1:CNC_ALL” to read the full program in the controller.
(3) Press “ Recv In ”
(4) After the confirmation of the file content, press “ Save File ”
Note:
When the program is in execution (S080=1), you must stop for S080 turning “0” to re-
operate the step 3 & 4.
Format for MCM Data Transfer:
%
O9002 Program number 9002 designated for MCM data
0000000 MCM #1
0000000 MCM #2
0000000 MCM #3
0000000 MCM #4
…… …….
........ ........
%
Notes:
1. The MCM data must start and end with a symbol of %.
2. The transmission MCM parameter’s program number is fixed to 09002.
3. No decimal point for MCM data transferred. The unit is 1/1000th of a second for
time and m for length or speed. One line for one MCM data only (7-digit).
For example, HOME speed on X-axis = 2500.00, it'll show 0250000 after
transferred. Software limit on Y-axis = -9999.999 cm, it’ll show –9999999.
9.1.3 Transfer MCM Data from PC to CNC Controller
Movement program:
1. The controller is not in a program execution state (where S080 = 0).
2. On PC side, make sure the transmission is ready to transmit.
Baud Rate should be correct when you execute HCON.exe (See section 10, Chapter
9 ). After entering Data Transmission Mode ( FileSvc ),
(1) Select “ Send File To CNC : TYPE >>> ”
(2) Select “ 2:MCM ”
(3) Press “ Open File ” to select the part program file for transmission.
(4) After the confirmation of file, press “ Send Out ”. PC will download the data
automatically.
Note:
1. The HCON is used to Upload the MCM parameter data onto the controller, and
the MCM parameter data are stored on the memory cache (RAM).
2. When the controller turns the power off, the MCM parameter data are stored on the
memory cache (RAM) via the battery mode.
3. To ensure permanent data storage on the memory cache (RAM), there is a need to