9 Appendix B – PC On-line Operation
9 - 11
Fig 9-4
1. Recv File fm CNC Read data from CNC
Recv File fm CNC:TYPE >>
0 : CNC PC read the main program.
1 : CNC_ALL PC read the full program.
2 : MCM PC read the parameters.
9 : Var-0099 PC read MCM#0~99
A : Var-0199 PC read MCM# 0~199
Q Var–8999 PC ead MCM#0~8999
R Var–9999 PC ead MCM#0~9999
On PC side, select data in CNC and press “ Recv In ”, PC will start reading the
data and storing them in memories temporarily.
Press “ Save File ” and enter the file’s name. The action is complete.
2. Send File to CNC Transfer PC to CNC
Send File to CNC: TYPE >>
0 : CNC PC transfer the part program to CNC.
1 : CNC PC transfer the part program to CNC.
2 : MCM PC transfer the parameter to CNC.
3 : PLC PC transfer PLC to CNC.
4 : CRT PC transfer self-editing screen to CNC.
5 : SYS PC transfer main system to CNC.
8 : PTN PC Transfer function tables to CNC.
9 : VAR PC Transfer user’s variable to CNC controller.
A : CYF Reserved for special designated servos.
B : 999 Reserved for special designated servos.
C : ARM PC Transfer ARM data to CNC controller.
A. After selecting the items, press “ Open File ”; enter the desired file’s name.
B. Wait for PC to complete the reading and store in the memories; press “ Send Out ”,
the action is complete.
C. V W2Flash shows that the data has been automatically burnt into Flash-Rom after
being sent out.
To Next Page
Loading...