HUST CNC H6D-T - Page 334

HUST CNC H6D-T Manual
9 - 10
Fig 9-3
Key Descriptions
PlcBit : Signal I/O/C/S/A status display
VarUser : Variables 0~9999 display
Var Sys : Variables 10000~ 13999 display
CncInfo : Particular variables system 10900~10999 display
McmData : MCM parameters display
Motion : Preserved
FileSvc : Data Transmission ( * Note 1)
MDIgo : Enter Single Bock command in the message box and press the key.
ReSet : Reset the controller
* Note : The functions of File Svc is as follows:
Recv File fm CNC……… Read data from CNC
Send File to CNC:……… Transfer PC to CNC
If the communication between the PC and the controller is normal, Cps is a non-zero value.
When the communication between the PC and the controller is normal, the DSR and
CTS will be highlighted in red background.