9 Appendix B – PC On-line Operation
9 - 9
9.1.12 HCON.EXE Program Qperation
Program Display:
Fig 9-2
Note:
1. Baud rate must be kept the same like the MCM# 520 setting in the controller from
CommPort Rs232 connectors.
2. Parity Check with H6D-T stays permanently as Even
3. Data Bit with H6D-T stays permanently as 7 Bits
4. Stop Bit with H6D-T stays permanently 2 Bits.
After the above 4 items are confirmed, please click “Link to CNC” to enter the software
operation interface.
To Next Page
Loading...