HUST CNC H6D-T - 9.2 HUST H6 D-T Transmission Modes

9 Appendix B – PC On-line Operation
9 - 13
9.2 HUST H6D-T Transmission Modes
HUST H6D-T series controllers have the following four transmission modes for the
user to select:
1. RS232 Mode
2. USB Device Mode (USB-H)
3. USB Host Mode (USB-D)
4. SDC Mode (SDC)
In JOG mode press the “File transfer” key for three seconds, it will enter the
transmission mode selection screen as shown in Fig 9-6.
Fig 9-6
The default is R232 Mode. The transmission mode can be switched by pressing the
function keys.
While switching the transmission mode, if a read error occurs:
1. Please press the “Reset” key.
2. Re-enter the transmission mode selection screen.
3. Switch to the R232 Mode to solve the problem.