HUST CNC H6D-T - Page 342

HUST CNC H6D-T Manual
9 - 18
9.5.2 File Upload Interface
Press the Upload function key on the transmission operating interface, you can enter
the screen as shown in Fig 9-12.
Fig 9-12
Upload CNC USB(SD CARD)
Example: Steps for uploading a parameter are:
1. First key in the file name (letters+ numerals shall be no more than 8
bits). Key in E456 and press Enter.
2. Press the Parameter function key.
3. After completion, you can see the E456.MCM file on the screen.
To upload data, first key in the file name and then press the desirable
function key.
Input
characters