HUST CNC H6D-T - 10 Appendix C - Method for using the most often used G10 command; 1. Operation Methods

10 Appendix C Method for using the most often used G10 command
10 - 1
10 Appendix C Method for using the most often used G10 command
If the user wishes to alter the machine parameters, the program, and user variables when
using the H6D-T controller, these operations can be achieved in the HCON interface or
by using the G10 command in the MDI mode of the controller.
1. Operation Methods
There are two types of operation methods; one is in HCON interface and the other
is in MDI mode.
Fig.10-1
(1)Operation in the HCON interface
a. Make sure the HCON and H6D-T controller communicate with each
other normally (see Appendix B for details).
b. Key-in the command in the Key In box. E.g., G10 P2001 .
c. Click the MDI Go button.
d. The command will be executed immediately.