HUST CNC H6D-T Manual
10 - 2
(2)Operation in MDI mode
Fig.10-2
a. Switch the H6D-T controller to MDI mode.
b. Edit and key-in the command. E.g., G10 P2001 , as shown in the
above figure.
c. Then press the START key.
d. The command will be executed immediately.
2. Operation of often used G10 Command
(1) G10 X____Y____Z____A____B____C____
You may use all the 6 axes simultaneously or any one of them selectively, by
using the G10, set coordinates of workpiece origin (G54~G59).
The procedures are as follows:
a. Execute manual homing to machine origin
b. Enter the MANUAL mode
c. Move the tool (axially) to the work origin to be set.
d. Enter the MDI mode, key-in G54 and press the START key.
e. If the tool position in step 3 is the work origin to be set (set in G54),
then carry out the following actions:
Press G10 X0. Y0. Y0. and ENTER
START ...... this completes the setting.
e2. If the tool position in step 3 has a distance with the work origin to be set,
then carry out the following actions: (suppose this distance is X=20.,
Y=100., Z=15.)
Press G10 X20. Y100. Z15. and ENTER
START......... this completes the setting.
To Next Page
Loading...