2 Operation
2 - 27
* Tool Compensation Screen
Click the “T.Radius / T.Offset” once to enter tool compensation mode. The following
screen displays:
Fig. 2-30
In this mode, it is possible to switch between two screens. Press the “soft key” to cycle
between tool-wear compensation, tool-length compensation, and parameter screens.
The tool length compensation screen is shown as follows:
Fig. 2-31
There are 40 groups respectively for tool-wear compensation and tool-length
compensation.
1. Set Tool Wearing Offset and Tool Length Offset according to the following
method:
To Next Page
Loading...