HUST CNC H6D-T Manual
2 - 28
a. Confirm the input type of Tool Wearing Offset and Tool Length Offset
(absolute value/increment value will be hinted at the upper right corner, and it
is not required to enter X/Y/Z, U/V/W), and then press lower soft key to
switch the input method. With “Cursor” key, move the cursor to the
parameter to be changed.
b. After entering the value key, press “Enter” key.
“Measuring”: The Hint text will appear after returning the Axis to Home
Position of the machine. Press this key and it will indicate
reverse white and flicker. Move the Tool with Hand Wheel for
accepting the OD and end face machining. Before the entire Tool
leaves the machining coordinates, move the cursor to the group to
be entered (under Tool length offset screen) for entering the
corresponding diameter value (X-Axis) or length diameter
(Z-Axis) and then the system will set the Tool length offset value
automatically.
2. Change Tool offset value during operation:
a. Lock by increment setting method (without affecting the input type not being
executed).
b. In the system parameters, set under the “Input max. wearing value during
operation” (default value: 2.000; max. value: 2.000mm).
3. Max. Wearing Offset Set Value: In the system parameters, set under the “Max.
Wearing Offset Value” (default value: 2.000; max. value: 20.000 mm), and the set
parameter value will be shown at the upper left corner of the Wearing Offset
screen.
To Next Page
Loading...