HUST CNC H6D-T Manual
2 - 44
Ex: The third block program N3 U480. W-480.
Changed to N3 U480. W-480. F0.2
Procedure:
1. Make sure the system is in “EDIT” mode.
2. Use / to move to the cursor to block N3.
3. Enter a command code and value to be added (changed), e.g. F0.2.
The screen shows as Fig. 2-40.
Fig. 2-40
1. Change U480. by entering U360;
To change an incorrect command, enter the correct command and press .
Delete a Command
Ex: The third block program N30 U480. W-480. F0.2
Changed to N30 U480.W-480.
Procedure:
1. Make sure the system is in “EDIT” mode.
2. Use the / key to move the cursor to block N3.
3. Enter a command to be deleted without values, e.g;
(No value is entered behind F). The screen shows as Fig. 2-41:
F 0 2
Enter
F
Enter
U 3 6 0
Enter
Enter
To Next Page
Loading...