2 Operation
2 - 43
8. Use the key to delete a program block.
Creating a Program Example:
Program 1
N1 G0 X0.Z0.
N2 G4 X1.
N3 G0 U480.W-480.
N4 G4 X1.
N5 M99
Action and description:
1. Confirm that the Controller has entered the program editing status.
2. Edit and input the node:
G 0 X 0 . Z 0 .
NEW
LINE
G 4 X 1 .
NEW
LINE
G 0 U 4 8 0 . W - 4 8 0 .
NE
W
LIN
E
G 4 X 1 .
NEW
LINE
M 9 9
NEW
LINE
If the program is longer than one page after completing the edition, use the Page Up
and Page Down to check if the programs in both pages are correct.
2.2.2.2. Editing a Program
We have created PROGRAM 1 in the previous section. The existing program change is
described in this section. Changing a program includes the following procedure:
Add (or Change) a Command
Delete
To Next Page
Loading...