HUST CNC H6D-T Manual
2 - 42
2.2.2 Program Editing
The program editing operation includes:
1. Program selection,
2. New program editing, and
3. Existing program change.
2.2.2.1. New Program Editing
Fig. 2-39
The following keys are used to edit programs:
1. Command keys.
2. Numerical keys
3. Cursors – Use or to move the cursor to the block to edit.
4. Used the or key to switch to the pervious or next page of the program.
5. Edit one node at a time (e.g. G90 X30.Z30 F0.2) and then enter.
6. Use the key to create or insert a new block.
Enter a new block in a new program or insert a new block in an existing program.
Press the key after entering a new block.
7. Use the key to apply/save the new changes.
Use the key after adding a command or changing a command value in an
existing block.
0 9
~
Insert
Insert
Enter
Enter
To Next Page
Loading...